The other is to shop around and threaten to cancel your service or leave for a competitor. It might be possible to use one antenna with a wide spread if the stations are close enough and strong enough, but this is definitely a case-by-case project. I'm sure this wire was run into the house at some time years ago, because it is hanging right next to the hole where cable enters my house. Here is an illustration of a beverage antenna. They will charge you either a flat fee to put in a new line or they will charge you by the hour if they are working on the wires in your walls. You must first determine the frequencies that all your wanted channels are broadcast, then look at the direction each comes from and design your antenna array with all this information in mind.
You may need to reorient the antenna to get channels. Those 2 ribbon cables are twin lead 300ohm for the antenna, and a 4 conductor rotor control cable. If you had the cable company install your lines in the past 15 years and your area was built out for Cable Modem Service then the install of the line to your Cable Modem should be what is called a Home Run line. Step 7 — Connect the Female End If your antenna supports coaxial cable, take a male to female coaxial cable and attach its female end to the coaxial port on the antenna. Most stations have one or two sub-channels as well and I was surprised how many channels I have. My personal favorite antenna is the.
These tactics are usually quite effective at getting some discount. Let me know about your experiences. What is the difference between the two cables? It looks like professionally competent grounding to me. Best Regards, Denny In strong signal areas a signal amplifier may not be needed. In our case, the antenna was a large, 1970s multi-directional behemoth that was hanging in our attic, unused for decades. I'm having internet issues right now so? About the Author James Clark began his career in 1985.
Yes, stripping the twin lead is a pain. Also post a picture of your antenna so we can see what you have. Essentially a flat sort of cable with the two wires in it, within the edges. Some of the older units are much sturdier than the newer ones that use a lot of plastic parts. The bad news is that instead of these distortions, digital broadcasts are either on working or off nothing, nada, zip. John k9uwa Roll Your Own 9 to 1 Unbalanced to Unbalanced Transformer You will need two of these ferrite Cores.
Negotiate with Cable Company If none of these options are appealing to you, you can try to. Don't take a chance on a lightning strike blowing up your radio. You can definately use that antenna. I would be deeply grateful if someone out there could help me out with this! My husband is not as optimistic as I am about hooking up the rooftop antenna. The antenna was invented by a guy named Dr.
Do the setup on the box and run a scan. A lot of people are Cutting The Cord and moving away from Cable and Dish Television subscriptions and installing their own antenna however doing this can be complicated if you also get your internet service from your Cable Company. He has more than four years of experience in appliance and electrical repairs. You will need to drill holes for this. If you did, please share it and sign up for my email updates. Get the cheaper non-amplified version if you have a lot of close stations on the Station Finder. The other end of the wire had that very same crocodile clamp with instructions to clamp to an available building ground.
You can choose from both indoor and outdoor antennas. A single coaxial cable hooks up the antenna to the television with a threaded metal fastener on the end of the cable. Preamplifiers are recommended for moderated and weak signal area and are not recommend for strong signal areas. They frequently turn out to be. A home run line is when one wire comes from the cable companies box outside or inside your house and runs directly to the cable modem. There are many arguments about twin-lead vs. You might not need a rotor depending where you live.
This site is independently owned and the opinions expressed here are my own. Also, look the antenna over for missing elements or corrosion, especially the contacts where the twin lead connects usually two wing nuts. If you have a rotator, check to see if it still works before replacing it. These antennas can be either a single direction. If that rotor hasn't been moved in years it probably won't turn, if for no other reason the rotor capacitors go bad and must be replaced.
Sometimes you need a different antenna. Determine the cable that leads to the modem and connect it to the internet feed. Place the U-shaped tip of each cable under the base of the corresponding screw-down terminal. Given its weaknesses with exposure to metal, weather, etc. Next determine if there is a signal splitter down line maybe in the basement etc. I currently use an indoor multi-directional antenna, but my reception is not as good as I would like it to be. Game Systems Do you have a game console like an Xbox or Sony Playstation.
Step 8 — Untangle the Cable Run the cable to the television or the converter box, as the case may be. Granted, lightning would arc any corrosion on the contact between the clamp and the pipe but it raises questions about the entire installation. From there, we had to run it through the ceiling of the basement, around a cold air return vent, and out into the crawlspace. There was a splitter to run the signal to various rooms in the house. If your antenna is stationery, then the next thing is to go to to see if any stations changed the location of their broadcast antenna.